BDS Suspension 3″ Lift Kit for the 2012-17 Jeep Wrangler JK 2 door 4WD – Standard Jeep or Rubicon.

Specifically intended for 2012-17 models, this system includes an exhaust extension kit that maximizes allowable wheel travel with the factory front driveshaft. This kit comes with 3″Pro-Ride Coil Springscapable of full coil bind and 2″ bump stop extensions to control the compression travel, but increase wheel travel.

Brake line relocation brackets are supplied to handle the added wheel travel. Many companies don’t include anything to correct your alignment, but BDS includes octo cam washers for the front lower control arms to fine tune the caster angle.

Fixed swaybar links are included for Rubicon models with the factory disconnect system, for non-Rubicon models choose between BDS Ultimate Sway Bar Disconnects or JKS Quicker Disconnects. In the rear, sway bar drop brackets are included instead of longer sway bar links to allow the use of a factory wheel and larger tire. To correct the rear axle shift from the lift, a rear frame mounted track bar relocation bracket is included.

The kit comes standard with NX series custom valved shock absorbers for a smooth ride.

BDS carries a large selection of accessories for Jeep JK’s so check out what is available for this 3″ lift by customizing your system.

• Tire & Wheel Combinations
• 35″ x 12.50″ w/16 x 8 and 4-1/2″ back spacing
• w/17, 18, 20 x 9 and 4.5″ back spacing

*Trimming may be required*

• Est. Installation:6 hours
• Difficulty Level (easy 1 – 5 complicated):2
• View completeVehicle Fitment Informationhere

Important Kit Notes

• 1. Removing the OE spring isolators will result in a 1″ lift if desired.
• 2. 124408 rear track bar or 124308 rear track bar relocation is recommended if using factory wheels
• 3. This kit is FMVSS No.126 Compliant
• The NHTSA’s Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well.
• BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.
• 4. This kit is right hand drive compatible.
• Follow right hand drive installation instructions when installing this kit on a right hand drive vehicle.
• 5. If using these rear sway bar links, the sway bar drop will not need to be installed. This also requires a wheel with 4.5″ backspacing or less for tire clearance.